Plan panels, posts and concrete from the actual fence path. Separate installed quantities from spare materials before you order.
Fence materials calculator
Results update as you type. Units: feet for layout, inches for hole and post dimensions, cubic feet for concrete.
Concrete dimensions & allowanceCurrent example: 10 in hole · 30 in fill · 0.6 cu ft/bag
Enter your planned hole dimensions, not a recommended footing size. All geometry defaults are examples. The post is assumed to occupy the full concrete depth; gravel below that depth is excluded.
inches; round, uniform holes
inches; exclude any gravel base
inches; measured size, not nominal size
inches
cubic feet per bag; use your product label
percent; applied to net volume once
Planning quantities only—not a structural design, permit check or contractor quote. Confirm spans, post types, hole dimensions and build details with your supplier and local requirements.
Shared corner and gate-boundary posts are counted once. This is an open path, not a closed loop, branching layout or disconnected set of fences. Different corner/gate post specifications may affect the quote.
Each run is rounded up separately. This assumes the final bay can be sized to fit; confirm whether your panel can be cut or requires a custom size. No picket, fastener or footing design is inferred.
Make a takeoff from the actual path rather than one combined length. Each corner starts a new run; a gate is a separate opening, not a panel.
Formulas used
Fence bays = Σ ceil(run length / bay width or spacing)
Installed posts = fence bays + gate openings + 1
These post counts apply to a single non-empty, connected open path. A zero-length project has zero installed posts. Every shared boundary is counted once.
Sections to buy = ceil[bays × (1 + material allowance / 100)]
Loose rails follow the same allowance, multiplied by your rails-per-bay input. Panels include their framing in this budget model.
Concrete is calculated from installed holes, minus the embedded post volume. Spare posts do not receive concrete. See concrete geometry →
Worked example · not a quote or design
100 ft straight fence
One 100 ft straight run at 8 ft installed bay coverage needs 13 bays and 14 installed posts. With a 10% material allowance, buy 15 panels. No extra rails are charged in prefabricated-panel mode. Spare posts are a separate purchase input.
Use installed post-to-post bay coverage from the product layout, not just the visible panel width.
This estimator assumes the last bay can be fitted to the remaining length. Some products require a custom panel rather than cutting.
Separate-infill mode budgets one infill section per bay plus the rails you specify. It is not a picket, screw or bracket counter.
Scope: level, regular bays along a single connected open path; identical cylindrical holes and solid posts. No closed loops, branches, disconnected runs or structural sizing. Calculation model updated October 1, 2026.
Common questions
Understand the estimate.
Does a corner need an extra post?
A junction between two entered fence runs shares one corner post in this connected-path model. The calculator does not add a second post at that junction. Confirm whether your specific corner detail needs a different arrangement.
Does the allowance add more installed posts?
No. The percentage increases purchased panels/infill and separate rails. Enter spare posts separately; they do not create holes or increase concrete volume.